Bearing Unit 1 Roller Eccentric Shaft Ø 14
€0.00
To build sliding carriages
To linearly guide loads, steel roller with ball bearings runs directly on shaft Ø 14 mm
Completely pre-assembled from roller profile I slot 8
To tighten the eccentric screw, a pin spanner is needed for the four holes of the adjusting washer
Roller: Steel
Screws: Steel
Excentric screw: Steel
Adjusting washer: Steel
Washers: Steel
Tension pins: Steel
Profile: Aluminum
Surface:
Roller: Zinc plated
Screws: Zinc plated
Excentric screw: Zinc plated
Adjusting washer: Zinc plated
Washers: Zinc plated
Tension pins: Zinc plated
Profile: Anodized
Tip:
Compatible Wiper and Lubricator Ø 14 for Roller Profile I Slot 8 (Set) see 091381S01
Delivery Countries:
Worldwide
| Pack Quantity: | 1 piece |
|---|---|
| Model: | Pre-assembled, steel |
| Weight (g): | 450.2 |
| ERP Number: | 147276 |
Product Portraits
Classifications
- Zolltarifnummer
- 84832000000
Certificates
Matching accessories
Description:Lubrication system for roller profile I to simplify maintenance of bearing units; Lubrication and wiping of particles while in use; Lubricating felt is delivered oil soakedMaterial:Housing: Plastic PA, glas fiber reinforced Lubricating felt: Felt Spring: Steel Screw: SteelSurface:Spring: Zinc plated Screw: Zinc platedColor:Housing: BlackTip:Semi-annual oil refill recommendedDelivery Countries:Worldwide